During operation, burners must be regularly maintained. Burner maintenance is crucial for the following three reasons:
Common burners on the market include: single-stage, two-stage, and PLC proportional control.
Most boiler thermodynamic calculations involve heat transfer between fuel, air, flue gas, water, and steam. To perform boiler heat transfer calculations
Our technicians have addressed the question of the impact of low-NOx burners on boiler operation. The main influencing factors are boiler design and coal quality
Direct-fired machine is a common gas water heater, and its working principle mainly involves the process of gas combustion and heat energy conversion.
Low-nitrogen burners are important equipment installed on industrial fuel oil boilers and gas boilers to control pollutant emissions.
Flue gas recirculation (FGR) is a technology that introduces part of the flue gas at the tail of the boiler back to the combustion area, mixes it with air or fuel
FSSS system consists of flame detection, oil layer control, coal layer control, power supply device and main logic cabinet. It has the following main functions:
Gas flares, also known as flare stacks, are important safety devices used in refineries and petrochemical facilities. They safely burn excess hydrocarbon gases
Industrial steam boiler auxiliary equipment includes burners, water supply pumps, control cabinets, economizers, condensers, sub-cylinders, boiler water treatment equipment, instrument valves, etc.
Methanol burner is a device that integrates the supply, atomization, air supply, ignition, flame detection and operation adjustment control of methanol, and is installed on the same cabinet to realize
Strengthening management and paying attention to the assessment of the technical level of boiler room managers and boiler operators plays an important role in boiler operation efficiency.
It should be close to areas with concentrated heat loads, and the layout of the heat pipes and outdoor pipe networks should be technically and economically reasonable;
If only the ignition sound is heard when the natural gas steam boiler is ignited, and the magnetic valve makes a "click" magnetic suction sound, it may be that the solenoid valve is damaged or aged
Before ignition, the gas boiler burner needs to go through two stages: the preparation stage and the pre-purge stage. After the first two stages are completed through self-inspection
